2009 Dodge Caliber Key Fob Programming
Updated 2026 Programming, battery & replacement fob
You can program a 2009 Dodge Caliber key fob yourself in a few minutes using a working key or remote, no dealer visit needed. Follow the steps below, then check the battery and the correct replacement fob (with FCC ID and part number) if you need a new one.
On these Chrysler, Dodge, and Jeep vehicles you can add a new key yourself if you already have two working keys. Vehicles from 2010 and newer must be done by an automotive locksmith or dealer.
Before you start
- Two working (programmed) keys
- Your new key, already cut
- 1Insert the first programmed key and turn the ignition to ON. Wait about 3 seconds, turn OFF, and remove the key.
- 2Within 15 seconds, insert the second programmed key and turn to ON. After about 10 seconds the immobilizer warning light comes on and you'll hear a tone. Turn OFF and remove the key.
- 3Within 50 seconds, insert the new key and turn to ON. After about 10 seconds you'll hear a tone and the immobilizer light stays on for 3 seconds — programming is complete.
- 4To add more keys, repeat from step 1 for each one.
Tips & troubleshooting
- If your vehicle had an ignition recall performed, DIY programming won't be available.
- Some 2009-and-newer Dodge Ram trucks need dealer programming — check with your dealer if you have one.
Replacement key fobs
Find your key type below, then match the FCC ID printed on the back of your existing fob — or, for a plain transponder key, the blank code — to be sure of the right part.
Remote Head Key
One piece: a cut metal blade with the lock/unlock buttons built into the head.
3/4-button Remote Head Key
Find on Amazon- FCC ID
- KOBDT04A, OHT692427AA, OHT692713AA, OHT692715AA
- OE part #
- 05135670AA, 05140447AA, 05143446AA, 05143608AA, 05170486AA, 05175786AA +72 more
- Frequency
- 315 MHz
- Chip
- PHILLIPS ID 46
Transponder Key
A cut metal key with a chip in the head. No buttons.
Transponder Key
Find on Amazon- Key blank
- Y159-P, Y159P
- OE part #
- 68399888AA
Photos show the OEM part for each number listed. Aftermarket replacements sold online are often slightly different in appearance — the FCC ID, not the shape, is what determines whether a fob will work with your car.
2009 Dodge Caliber key fob battery
Your 2009 Dodge Caliber key fob uses a CR2032 3V lithium coin cell. A fresh one typically lasts 3–5 years.
Find CR2032 batteries on AmazonHow to replace the battery
- 1 Look for a small notch or screw on the side of the fob where the key blade meets the buttons.
- 2 Pry the housing apart with a coin or small flathead (or remove the screw).
- 3 Pop out the old coin cell, noting its orientation.
- 4 Insert the new battery the same way up, then snap the case shut.
- 5 Test the buttons — if they work, you're done.
Battery tips
- Use a fresh, name-brand 3V lithium cell — bargain cells drain quickly.
- Try not to touch both faces of the new battery; skin oils shorten its life.
- If the buttons still don't respond after a new battery, the remote may need re-syncing or programming.
We may earn a commission on qualifying purchases made through links on this page, at no extra cost to you. It never affects which product we recommend. Learn more.
Rather hire a pro?
See what it actually costs, broken out by dealer, locksmith, and DIY: